Skyranger Nynja, Build Manual

Page: 226 / 278

226
Nynja Build manual 1.4d
the tapered edge of the elevator, both distances measured at 90

to the
respective edge.
Figure 312 position of hole in lower elevator surface.
g) Thread the inner trim cable through the holes in the fabric and into the outer
cable and push it steadily all the way through
h) Attach the loop at the end of the trimmer cable to the top trim tab control horn
with a bolt and plastic ‘top hat’ spacer.
The cable goes on the inboard side of the horn.
Figure 313 cable attachment on trim tab horn.
i) Attach the short cable to the lower trim tab horn. It should be orientated so
that the forward end has the reinforcing thimble eye in the loop. Attach two
springs in parallel from this to the thimble eye emanating from the cable
bracket on the lower side of the elevator leading edge (shown in fig 312)
140mm
170mm