Skyranger Nynja, Build Manual

Page: 129 / 278

129
Nynja Build Manual 1.4d
Figure 154 prop tape over wing tip U-brackets to prevent chafe.
If using Xlam coverings you can apply anti corrosion fluids such as
ACF50 to all wing frame parts, and inside and outside the tubes, prior
to covering. Waxoil inside the tubes can also be used but be sparing or
weight will rise!
h) Lay the wing cloth on the clean surface, next to the frame, with the lower
surface of the wing upwards.
The lower surface is the one with the zips.
Take care when handling the coverings to keep your hands (and any
tools etc. you may handle) clean at all times.
i) Remove the turnbuckle from the drag cable.
Make sure that the cable with the turnbuckle is over the top of the fixed
cable.
j) Remove the compression tubes tu38 , the innermost cross-tube in the wings.
k) Plastic stiffeners are supplied which should be slid in the root end of the
leading edge pocket in the sail just so far as they are completely covered by
the leading edge pocket. It can be done later but is easier to get in now. These
just smooth the leading edge fabric in this inner bay which can otherwise
wrinkle where the sail is pushed upwards over the head of the vertical bolt in
the Leading edge.