Skyranger Nynja, Build Manual

Page: 72 / 278

72
Nynja Build Manual 1.4d
d) The outer clamp should be positioned as far outboard as possible, against or
close to the plates holding the base of the rear cabin uprights SKR6 .
Don’t
fully tighten yet.
Figure 82 outer U-clamp position.
e) Fit the steel drag braces (Fig 80), and then tighten all attachment bolts.
The forward end attaches under the SKR144 triangulation side tube (which
should be fitted at this time assemble as per Figure 80. Ensure the attachment
bolt does up tight without becoming thread-bound, It may be necessary to add
another washer under the nut to achieve this balance. Bolts should be fitted
head down as shown. Note the bolt that attached the SKR144 is longer than
the rear bolt
– check they are correctly orientated so.
The lower rear end goes under the gear leg and the upper rear end goes over
the top of the upper clamping block. Ensure the front attachment bolt does up
tight without becoming thread-bound, but also has no thread bearing on the
drag brace. It may be necessary to adjust with washers under the nut to
achieve this balance.
Figure 83 rear and forward ends of starboard drag brace
8-40 saddle washer
3mm plastic washer
Metal washer under
bolt head and nut