Skyranger Nynja, Build Manual

Page: 162 / 278

162
Nynja Build Manual 1.4d
Figure 208 radiator position and attachment
d) With cowling in position. Check clearance from oil cooler to the heater jacket
intake on the exhaust. Cut this back as required to ensure a 10mm or so gap.
Install the hose from the port side of the oil cooler to pass around the
starboard side of the engine in a smooth curve to the connection on the oil
pump inlet in the front of the engine. The hose from the starboard side of the
Oil cooler should be routed to the OUT connection on the oil tank.
e) Remove the cowling now and Install the hose from the sump connection
beneath the engine passing beneath the lower cylinder head water pipes, but
above the exhaust pipes, to connect with the inlet on the oil tank (the angled
one towards the side of the tank, furthest from the filler cap).
f) Check that the oil pipes do not come close to or contact any part of the
exhaust, or anything else which may chafe or otherwise affect them.
Use cable ties to secure them to the engine / water pipes etc. when these
have all been fitted.
Figure 209 routing of oil hose from oil cooler connection to outlet on oil tank. Note use of
cableties through short lengths of fuel tubing to act as standoffs on fuel pump and inlet
manifold to secure hose.