Skyranger Nynja, Build Manual

Page: 76 / 278

76
Nynja Build Manual 1.4d
b) Temporarily fit the two small steel pushrods SKR44 and SKR45 linking the
steering bar to the rudder pedals. Use the middle holes at this stage.
One pushrod is longer than the other to account for the offset of the
rudder pedal pivot bars.
c) UKMOD: Rubber grommets must be fitted between the box section and
steering pushrods and between the pushrods and the pedals to facilitate angle
change at steering extremes.
Ensure that you have fitted these, as otherwise the steering will not
operate properly.
Make sure all the other metal and plastic washers are removed. Fit one
of the plastic washers supplied in the bag with the grommets under
each bolt head
Do not tighten the bolts so much that you completely squash the rubber
grommets!
d) Temporarily fit the pushrods to the rudder pedals, using the middle holes on
the pushrods and the second hole from the top of the pedals.
e) Pedals may be adjusted rearwards by using one or both of the outer holes in
the pushrod. However using the inner holes to move pedals forwards is not
recommended as it can cause fouling with the rudder stop cables which are
fitted later.
f) Note the bolts used at both ends of the pushrods should be fitted with split-
pins once adjustments are finalised.
Figure 87 nose wheel steering bar, with rubber grommets between pushrods and box section
and pushrods and rudder pedals, note the white plastic washers shown near the arrows should
not be fitted.