Skyranger Nynja, Build Manual

Page: 217 / 278

217
Nynja Build manual 1.4d
Note they are are handed pairs! The ends of the upper part of the
hinges overlap the fixing holes in the angle. The hinges should be
positions so their lower edges are 10-15mm in from the edges of the
TU34 and TU6 tubes.
File / dremel cut, the angle so that the hinges can be inset, so the edge
aligns with the hinge axis.
Figure 297 Upper door frame hinges. Top pictures show rear of port door, outside and inside.
Lower pictures show front of port door, outside and inside. Angle is white plastic in pictures,
kit supply is 20x20 aluminium angle.
e) Fix the hinges to the angle. Use 4mm aluminium rivets.
f) Drill though the holes made in step c) above to make the holes in the
overlapping hinge peices. Temporarily fix the assembly in position on the
TU34 and TU6 tubes.
g) Offer the upper doorframe up into position.
It should fit in the opening with even spacing
– again of 10-15mm. Use
some spacers to sand it off from the lower door frame and TU34 at this
spacing. Adjust the bends as required to get a nice fit.