Skyranger Nynja, Build Manual

Page: 159 / 278

159
Nynja Build Manual 1.4d
f) The front Starboard pipe incorporates a sliding joint. Leave tightening this pipe
until last. Before fully tightening the bolts, slacken the clamp and adjust the
length so that all four pipes fit evenly into the exhaust.
If this pipe is adjusted too short the front starboard and rear port pipes
will not seal properly and if too long the front port and rear starboard
pipes
will not seal properly. This will result in an exhaust blow or ‘tick’.
When happy with the fit tighten the mounting bolts and the clamping
bolt. Do a final check with a good firm ‘wiggle’- you should not be able
to see/ feel any uneven seating.
Figure 203 Port front pipe, showing clamp on sliding section
g) Fit the twin outlet pipes. Adjust their position so they are clear of the firewall by
approximately 20mm, then tighten. Lockwire between the safety loops (this is
to prevent loss of a pipe if the clamping comes loose for some reason).
Figure 204 overview from port side.