Skyranger Nynja, Build Manual

Page: 145 / 278

145
Nynja Build Manual 1.4d
d) Temporarily tighten the bolts at the end of the throttle bar.
e) Fit the plastic stops on the mounting plates.
Note that two of the stops are drilled off centre. They should be fitted in the
rear positions on the plates and are rotated to provide fine idle adjustment
later.
f) Check that the spacing and centralisation of the parts holding the tops of the
cabin uprights has not been disturbed by the fitment of the throttles
g) The throttle cables attach to an arm that will be hidden in the instrument
console.
Figure 179 throttle cable arm
h) This arm has a threaded insert in its base. The throttle torque tube must be
drilled to fix this arm
Mark the position for The 6mm hole 105mmto the left, from the centre of the
cabin. The control stick torque tube makes a useful centre reference for this
measurement.
i) To drill the hole it is best to remove the torque tube assembly and drill on the
bench
– preferably using a pillar drill.
Be careful to drill the centre of the tube. Vertical alignment should match the
vertical part of the throttle handles where it passes up out of the machined end
fitting
– figure 179.
Cable arm