Rohde & Schwarz FPC1000, User Manual

Page: 204 / 291

Remote Control
FPC1000
189
User Manual 1178.4130.02 ─ 02
Example:
//Couple the step size to the span
FREQ:CENT:STEP:LINK DIVT
[SENSe:]FREQuency:INPut:MODE
<InputMode>
This command selects the frequency input mode. Select the channel frequency mode
only if you want to work with channel tables. In this case, the input of the center fre-
quency is not a frequency value, but a channel number.
Parameters:
<InputMode>
FREQuency
Center frequency is defined in terms of a frequency (in Hz).
You can define the frequency with
[SENSe:]FREQuency:
CENTer
.
CHANnel
Center frequency is defined in terms of a channel.
You can select the channel with
[SENSe:]CHANnel
.
*RST: FREQ
Example:
//Set the frequency mode to work with channel tables
FREQ:INP:MODE CHAN
[SENSe:]FREQuency:MODE
<OperationMode>
This command selects the measurement domain (frequency or time).
In the time domain (CW and FIXed), set the frequency with:
●
[SENSe:]FREQuency:CENTer
In the frequency domain (SWEep), set it with:
●
[SENSe:]FREQuency:CENTer
●
[SENSe:]FREQuency:SPAN
●
[SENSe:]FREQuency:STARt
●
[SENSe:]FREQuency:STOP
Parameters:
<OperationMode>
CW
Select the time domain (span = 0)
FIXed
Select the time domain (span = 0)
SWEep
Select the frequency domain (span > 0).
*RST:
SWEep
Example:
//Activate frequency domain measurements
FREQ:MODE SWE
Remote Commands of the Spectrum Application
北京海洋兴业科技股份有限公司（证券代码：839145） www.hyxyyq.com