Rohde & Schwarz FPC1000, User Manual

Page: 135 / 291

The Receiver Application
FPC1000
120
User Manual 1178.4130.02 ─ 02
10.6 Trigger Configuration
Access
: "Sweep" > "Trigger"
Access
: "Setup" > "Config Overview" > "Trigger" (selected settings)
Remote commands to trigger measurements:
●
Chapter 13.11.6, "Trigger" , on page 233
Trigger settings in the receiver application described elsewhere:
●
"Free Run": Chapter 9.7, "Trigger Configuration" , on page 90
●
"External Rise": Chapter 9.7, "Trigger Configuration" , on page 90
●
"External Fall": Chapter 9.7, "Trigger Configuration" , on page 90
10.7 Trace Configuration
Access
: "Trace"
Access
: "Setup" > "Config Overview" > "Analysis" (selected settings)
Remote commands to configure traces:
●
Chapter 13.11.7, "Traces" , on page 234
Trace settings in the receiver application described elsewhere:
●
"Trace Mode": Chapter 9.8.1, "Trace Mode" , on page 93
(Note that the "Blank" and "View" trace modes are not available in the receiver.)
●
"Detector": Chapter 9.8.2, "Detector" , on page 94
The receiver application only supports the "Max Peak", "Average" and "RMS"
detector.
In addition, the receiver application also has the "Quasi Peak" detector. The quasi-
peak detector displays the maximum value weighted to CISPR 16-1-1 that was
detected during the measurement.
●
"Memory" / "Trace > Memory": Chapter 9.8.3, "Memory Traces" , on page 96
●
"Trace Style": "Selecting the trace style" on page 113
10.8 Marker Configuration
Access
: "Mkr"
Access
: "Mkr
→
"
Remote commands to control marker:
●
Chapter 13.11.8, "Marker" , on page 234
Note that markers are only available for frequency scans .
Marker settings in the receiver application described elsewhere:
●
"Mkr" > "Marker <x>": Chapter 9.9.1, "Marker Positioning" , on page 99
Marker Configuration
北京海洋兴业科技股份有限公司（证券代码：839145） www.hyxyyq.com