21.2.7. Concentration Unit
When you pull down the Concentration Unit menu, select the desired gas concentration
unit (there are other types of units).
ppm
%
ppb
mg/m
3
ug/m
3
%LEL
%VOL
%CH
4
21.2.8. Purge Time (Sec.)
Type to set the number of seconds for the system to purge with fresh air after performing
a bump test or calibration.
21.2.9. Soak Time (Sec.)
Type to set the number of seconds for the system to allow the sensor to be pre-exposed to
calibration gas before bumping or calibrating.
Summary of Contents for AutoRAE 2
