24. Wireless Operation
The AutoRAE 2 Controller can communicate wirelessly with a PC running ProRAE
Studio II, and operates in the same manner (that is, the wireless connection substitutes for
a hardwired connection). This requires purchasing an optional WiFi Adapter and
configuring it properly for your network. It also requires configuration of the AutoRAE II
Controller.
Software and firmware requirements:
ProRAE Studio 2 (PRS2) V1.8.1 Build 133 (or newer)
AutoRAE2 controller firmware V1.20 (or newer)
AutoRAE 2 Utility V1.02 Build 105 (or newer)
Note:
This procedure has been tested with NetGear’s WNCE2001 Universal Wi-Fi
Internet Adapter (or equivalent)
24.1. Part One: Configure The AutoRAE 2 Network Interface
1.
Connect an Ethernet cable between the PC and the AutoRAE 2 Controller.
2.
On the AutoRAE 2 Controller, enter Function and then Settings choose “Select.”
3.
When the dialog box appears, input your password. Select “Done.”
4.
Now choose Network Settings and “Select” again. The first option is DHCP
Enable/Disable (see Figure 1).
Figure 1. AutoRAE2 Network Setting Menu.
Summary of Contents for AutoRAE 2
