20. Preparing For Bump Testing & Calibration
Before performing a bump test or calibration, the AutoRAE 2 must be set up (refer to
Section 16 for details), have an SD card with sufficient available memory in it, power
applied, and calibration cylinders connected.
20.1. SD Memory Card
The AutoRAE 2 Controller electronically stores system files and reports on a standard
SD memory card, as well as system-specific data.
IMPORTANT!
The 2GB SD card that comes with the AutoRAE 2 Controller is pre-formatted and ready
for use (RAE Systems P/N 550-0300-000). If you purchase an SD card from another
vendor, it can be greater than 2GB, but only 2GB of space will be used by the AutoRAE
2 Controller.
Note:
The SD card inside AutoRAE 2 can only be used for AutoRAE 2 recording. Do not
save other files to the SD card.
Although a 2GB SD card can hold approximately 3 years’ worth of daily bump,
calibration, or combined data for 500 instruments, transferring reports from the SD card
to a PC every 6 months is recommended. This enhances data security and speeds the
data-transfer process.
IMPORTANT!
The AutoRAE 2 cannot operate without an SD card in its slot.
Note:
If no SD card is in the slot when the AutoRAE 2 Controller is turned on, or the SD
is locked, or if the SD card is removed during operation, the display shows this message:
ERROR!
Code: 4001
SD card is missing or locked. Please
check the SD card and restart the
system.
Summary of Contents for AutoRAE 2
