12.11.
Recalling Stored Settings
If you have previously stored settings in a separate file, you can call them up so that you
can modify them and/or apply them to AutoRAE 2 Cradles. This feature is especially
useful if you have multiple individual Cradles to which similar settings need to be
populated.
1.
Click the “Open A Saved File” (folder) icon.
2.
Find the ProRAE Studio configuration file you want to upload from your PC (it
will have a .prs suffix).
3.
Click “Open.”
Note:
Opening a file overwrites any settings (modified or unmodified) already in the
active ProRAE Studio II session.
You may now modify or upload these settings.
12.12.
Uploading Settings To Multiple AutoRAE 2 Cradles
You can apply settings to multiple cradles. Simply connect one cradle to the PC and
upload the settings as outlined in the previous section, disconnect that cradle, connect
another, and then upload settings.
12.13.
Exiting Programming
When you are done programming and have saved the settings, do the following:
1.
Exit ProRAE Studio II.
2.
Disconnect the USB cable between the PC and the AutoRAE 2 Cradle.
3.
Press the “Bump” key on the AutoRAE 2 Cradle (the display changes from “PC”
to the active gas configuration, G8).
Summary of Contents for AutoRAE 2
