Rae AutoRAE 2, User Manual

Page: 118 / 121

25. Wall Mounting A Controller & Cradles
The AutoRAE 2 can be used on a flat surface, or it can be mounted on a wall. This
requires drilling holes into the wall and inserting screws to hold the AutoRAE 2.
Note: Handheld PID Cradles cannot be wall-mounted.
Important! Make sure the wall is strong enough to support the weight of the AutoRAE 2
Controller and attached AutoRAE 2 cradles. If necessary, mount a piece of plywood or
use other reinforcement for the wall.
Use a pair of slotted TS35 DIN rails (35mm high x 7.5mm deep) cut to slightly longer
than the length of the assembled system, and attach to a strong wall or other rigid surface
using low-profile screws. Make sure the center-to-center spacing of the slotted rails is
135 mm.
Once the rails have been firmly fastened to the wall, slide the AutoRAE 2 Controller
from the left side onto the rails. Then slide an AutoRAE 2 Cradle onto the rails from the
right side. Make sure that the last AutoRAE 2 Cradle has the Terminal Adapter from the
AutoRAE 2 Controller attached.