Information is available that describes the detected problem:
If there is a mismatch, check the instrument’s settings in Programming Mode, as well as
the settings programmed for the AutoRAE 2 via ProRAE Studio II.
If all instruments in the cradles warm up and all test without errors or incompatibilities,
then they are listed as “Ready”:
Summary of Contents for AutoRAE 2
