6.9.2. Installing The Instrument In the Cradle
If the instrument is equipped with a Quick Connector, install the instrument in the cradle:
1.
Remove the inlet probe by pressing down on both sides of the base and releasing
the probe.
2.
Make sure the monitor is either turned off or is in AutoRAE 2 Communications
Mode.
3.
Place the instrument into the cradle face-down, making sure that it is aligned
correctly with the contacts on the AutoRAE 2 Cradle’s charging port. There are
two alignment points on one side and one alignment point on the other side,
designed to mate with matching points on the bottom of the instrument.
4.
Press in on the capture mechanism to lock the instrument in place.
For MiniRAE Lite, MiniRAE 3000, or ppbRAE 3000:
For UltraRAE 3000:
Summary of Contents for AutoRAE 2
