Rae AutoRAE 2, User Manual

Page: 82 / 121

You have five seconds to change your choice. After that, a screen with a list of the
selected instruments and your choices of Bump or Cal. are shown. If no instrument is in
one of the cradles, or if you did not choose either option, then there is no selection
indicated.
You can start the bump tests and calibrations immediately by pressing [Y/+]. Otherwise,
a countdown begins. When it reaches zero, the bump and calibrations are initiated. You
can quit during this time (press [N/-]).
The instruments will undergo a bump test or calibration using parameters stored in the
attached AutoRAE 2 Controller. (A stand-alone AutoRAE 2 Cradle uses the
configuration stored in its internal configuration.)