21.6. Recalling Stored Settings
If you have previously stored settings in a separate file, you can call them up so that you
can modify them and/or apply them to the AutoRAE 2 system. This feature is especially
useful if you have multiple individual systems to which similar settings need to be
populated.
1.
Click the “Open A Saved File” (folder) icon.
2.
Find the ProRAE Studio file you want to upload from your PC (it will have a .prs
suffix).
3.
Click “Open.”
Note:
Opening a file overwrites any settings (modified or unmodified) already in
the active ProRAE Studio II session.
You may now modify or upload these settings.
21.7. Uploading Settings To Multiple AutoRAE 2 Systems
You can apply settings to multiple AutoRAE 2 systems. Simply connect one system to
the PC and upload the settings as outlined in the previous section, disconnect that system,
connect another, and then upload settings.
21.8. Exiting Programming
When you are done programming and have saved the settings, do the following:
1.
Exit ProRAE Studio II.
2.
Press [MODE] on the AutoRAE 2 Controller to exit Communications Mode.
3.
Disconnect the USB cable between the PC and the AutoRAE 2 Controller.
Summary of Contents for AutoRAE 2
