4. Installing End Caps For Stand-Alone Use
The AutoRAE 2 Cradle is shipped with left and right end caps, which are intended to protect
and label the ports on both sides of the AutoRAE 2 Cradle. The one for the “input” side (left
end cap) snaps on, while the one on the other side (right end cap) gets slipped into its position
and is then secured with two screws (plastic caps are included, to hide the screws).
Note:
The same end caps fit all cradle models.
Slide the cap over the end
and snap it into place.
Slide the second cap into
place.
Insert the two screws.
Tighten the screws.
Do not overtighten!
Press the caps over the
screws.
Summary of Contents for AutoRAE 2
