10.
Charging An Instrument’s Battery
Placing an instrument in the cradle and locking it in position allows the instrument’s
battery to be charged.
When power is applied to the AutoRAE 2 Cradle and the instrument’s battery is
charging, the LED glows red.
The LED glows green when the battery is fully charged:
11. Removing An Instrument From A Cradle
When you want to remove an instrument from a cradle, press down on the red release
lever until the capture mechanism springs forward, releasing the instrument. Then lift the
instrument from the cradle, inlet side first.
IMPORTANT!
If you remove an instrument that is warming up or under bump test or calibration, the
process is interrupted, and requires that you place the instrument back in the cradle to
restart the process. An interrupted process cannot be resumed.
Summary of Contents for AutoRAE 2
