Omron F3SG-PG Series, User Manual, Page: 99 / 473

69
F3SG-SR/PG
User’s Manual
Chapter
2
PSDI
System Operation and Functions
E
2-10-2. Factory Default Setting
The PSDI function is set disabled.
2-10-3. Setting Change using Intelligent Tap
It is unable to change the setting of this function using the DIP Switch of the Intelligent Tap.
2-10-4. Setting Change using SD Manager 3
The following setting can be made using SD Manager 3.
* Set the minimum pressing time of the reset switch and pre-reset switch. The same minimum pressing time is applied to both
the switches.
It is recommended that the Position 2 of the DIP Switch be set at OFF (DIP Switch Disabled).
For the details of the setting change using SD Manager 3, refer to Chapter 4 Setting with SD Manager 3 .
Function Initial value Configurable value or numerical range
PSDI function Disabled Disable/Single break/Double break
Minimum pressing time of reset switch * 100 ms 100 to 500 ms in 100-ms increments
T1
min.
T1
min.
T2
min.
D u mmy
b reak
D u mmy
b reak * 1
D u mmy
b reak * 1
Unintended
b reak
Feeding
parts
Removing
parts
Feeding
parts
T3
min.
T4
min.
T2
min.
T3
min.
T6
Machine stops
T4
min.
T2
min.
T3
min.
T4
min.
T5
以上
T5
min.
Do ub le Break
Reset s w itch (S1)
Press position
switch (S3)
OSSD
T1: Minim u m pressing time of reset s w itch, config u ra b le b y 100 ms in a range of 100-500 ms
T2: Minim u m b reak time (300 ms)
T3: Minim u m u n b locked time d u ring the time from remo v ing to feeding parts. T3 = T1
T4: Minim u m b reak time (300 ms)
T5: Minim u m pressing time of press position s w itch. T5 = T1
T6: W ait time u ntil do ub le b reak is complete (30 s or less)
*1. W hen the machine is stopped b y u nintended b lock in the middle of pressing of parts, operation of the reset s w itch (S1)
and then do ub le d u mmy b reak are needed for reinitiation of the machine cycle.
*2. W hen A u xiliary O u tp u t is set to PSDI Information b y the SD Manager 3.
AUX* 2
SEQ indicator
(yellow)
Beam state
Un b locked
Blocked
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
O N 1 time O N 3 times Solid-O N
Machine restarts