Omron F3SG-PG Series, User Manual, Page: 123 / 473

93
F3SG-SR/PG
User’s Manual
Chapter
2
Mu
ti
ng
System Operation and Functions
E
The values of T1
min
and T1
max
can be changed by the SD Manager 3.
Time t2 [ s ] for a workpiece to pass the F3SG-SR/PG’s detection zone after passing the muting sensor
A1 is:
t2 = d2 / VEquation (3)d2 [ m ] : Distance between muting sensor A1 and F3SG-SR/PG
V [ m/s ] : Approach speed of a workpiece
Time t2 in Equation (3) must satisfy following condition:
t2 < T5Equation (4)T5: Exit-only muting delay time
The value of T5 can be changed by the SD Manager 3.
Sensors must be installed so that person’s passing should not cause the MUTING state.
Also, the muting sensors and F3SG-SR/PG must be installed so that MUTING state caused by a
workpiece should be ended before the next workpiece arrives at the first muting sensor.

Timing chart
W orkpiece W orkpiece W orkpiece W orkpiece
F3SG-SR/PG A1 B1 F3SG-SR/PG A1 B1
Hazardo u s zone Hazardo u s zone
Mo v ing direction Mo v ing direction
T1min: M u ting inp u t time limit v al u e (minim u m)
T1max: M u ting inp u t time limit v al u e (maxim u m)
T2: M u ting time limit
T3: Maxim u m allo w a b le m u ting signal interr u ption
T4: M u ting end w ait time
T5: Exit-only m u ting delay time
T2 max.
T1min to T1max
T3 (0.1 s) max.
8 0 ms max. *
T3(1 s) max.
T5 max.
T4 (1 s)
* 102 ms max. w hen the
Intelligent Tap is connected
to the F3SG-SR.
Green b linking
Orange b linking
O N
OFF
M u ting inp u t A
(M u ting sensor A1)
M u ting inp u t B
(M u ting sensor B1)
Un b locked
Blocked
OSSD
O N
OFF
MUTI N G state
Ena b led
Disa b led
O N
OFF
Beam state
ABI indicator
O N
OFF