Omron F3SG-PG Series, User Manual, Page: 418 / 473

388
Chapter
6
Wiring Exa
m
p
le
s
(f
or F3
SG-SR/PG)
F3SG-SR/PG
User’s Manual
Input/Output Circuit and Applications
6-2-1-5. Manual Reset Mode with EDM and Y-Joint Plug/Socket Connector
[Wiring Example (F3SG-SR and F3SG-PGA-A/-L)]
• When using the Y-Joint Plug/Socket Connector (F39-GCNY2), the following functions are not available.
- External Test
- Operating Range Selection
- Wired Synchronization
• When a functional earth is necessary, wire an earth cable according to the example in
6-2-1-1. Auto Reset Mode with
Optical Synchronization and EDM Unused
. Also refer to 5-4-4. Functional Earth Connection for more information.
F3SG-SRA

F3SG-PGA-A/-L

F3SG-SRB

F3SG-PGA-C
F39-JGR3K-L and F39-JG
□
B-L
F39-GC N Y2
F39-JG A-D
24 V DC
W iring for N P N *1
*3
24 V DC
Timing chart
F39-JGR3K-D and F39-JG □ B-D
I N
PLC *2
KM1
KM2
M
KM1
KM2
S1
KM1 KM2
Beam state: Un b locked
Blocked
Reset s w itch (S)
OSSD
S1: Locko u t/interlock reset s w itch
KM1, KM2: Safety relay w ith forci b ly g u ided contacts (G7SA) or magnetic contactor
M: Motor
PLC: Programma
b le logic controller (Used for monitoring only. N OT related to
safety system.)
OSSD 1 (Black) OSSD 2 (
W
hite)
24
V
/0
V
(Bro
w
n)
0
V
/24
V
(Bl
u
e)
AUX (Red) MUTE B (Pink) MUTE A (Gray) RESET/EDM (Y
ello
w
)
Recei
v
er
Emitter
*1. Reverse the polarity of the power supply when using in the NPN system. Select a
PLC of PNP or NPN type according to the system of your application.
*2. When connecting to the PLC, the output mode must be changed with the SD
Manager 3 according to your application. Refer to Chapter 4 Setting with SD
Manager 3 for more information on setting this function by the SD Manager 3.
*3 This is the case for a PELV circuit.
*4 Set the function with the DIP Switches on the Intelligent Tap or the SD Manager
3, restore the settings to the F3SG-SR, and perform wiring according to the
wiring diagram.

: Indicates a switch position.
Function
Setting
DIP switch SD Manager 3
EDM *4 EDM Enabled
[External device monitoring] : Enable
Interlock *4 Manual Reset [Start interlock] : Enable
[Restart interlock] : Enable
Operating Range Selection Long
Non-Muting system Perform wiring according to the wiring diagram.
N/A [Muting] : Disable *4
External Test not used N/A
Optical Synchronization Connect the wires according to the diagram above.
㻟 㻻㻺
㻠 㻻㻺
㻡 㻻㻺
Intelligent Tap Needed