Omron F3SG-PG Series, User Manual, Page: 217 / 473

187
F3SG-SR/PG
User’s Manual
Ch
apt
e
r
3
In
te
lligent
Tap Applicat
ion Examp
le
Setting with Intelligent Tap
E
4.
If the intelligent tap is not connected yet, connect it to F3SG-SR/PG. Refer to the chart in 3-10-1.
Setting F3SG-SR/PG with DIP Switch ,

Step 5. to make sure that the system has the configuration
with intelligent tap.
5.
Turn on power of the intelligent tap and F3SG-SR/PG.
6.
Press and hold the Push-SW of the intelligent tap for 1 second or longer.
The setting of F3SG-SR/PG are backed up in the intelligent tap.
7.
Check the indicators if backup is complete.
If the indicators are different from the above, turn off power of the intelligent tap and F3SG-SR/PG,
make sure that the wiring is proper, and go back to step 2. to perform the steps again.
8.
Turn off power of F3SG-SR/PG.
9.
Set the DIP-SW channel 1 ON.
10.
Turn on power of the intelligent tap and F3SG-SR/PG.
11.
Check that F3SG-SR/PG runs as intended.
If it does not, turn off power of the intelligent tap and F3SG-SR/PG, make sure that the wiring is proper,
and go back to step 2. to perform the steps again.
12.
Turn off power of the intelligent tap and F3SG-SR/PG.
Push-SW
DIP-SW
Bluetooth
®
Communication Unit
Connector
USB Type-C TM
Connector
<Status of indicators at normal end>
OUT :Flashing yellow at 0.5 second cycle
(quick flashing)
ERR :Not lit
DIP-SW
1 2 3 4 5 6 7 8
O N
Push-SW
DIP-SW
Bluetooth
®
Communication Unit
Connector
USB Type-C TM
Connector