Omron F3SG-PG Series, User Manual, Page: 220 / 473

190
Ch
apt
e
r
3
In
te
lligent
Tap Applicat
ion Examp
le
F3SG-SR/PG
User’s Manual
Setting with Intelligent Tap

If intelligent tap's ERR indicator is red ON
The sensor model and/or configuration settings stored in the intelligent tap differ from those that are
actually connected. Use SD Manager 3 to modify the settings stored in the intelligent tap so that they
should correspond with the actual sensor configuration, and go back to step 3. to perform the steps
again.

If the OUT indicator of the intelligent tap flashes green in 2.0 second cycle
The restoration is not performed.
The number of beams of the sensor stored in the intelligent tap differs from that of the sensor actually
connected.
If a function related to the number beams is used, such as blanking, use SD Manager 3 to modify the
settings stored in the intelligent tap so that they should correspond with the actual sensor
configuration, and go back to step 3. to perform the steps again.
If no function is used that is related to the number of beams, press and hold the Push switch of the
intelligent tap for 1 second or longer. Restoration starts.
8.
Turn off power of the intelligent tap and F3SG-SR/PG, then turn on power of them.
The settings are not enabled unless the intelligent tap and F3SG-SR/PG are restarted.
9.
Check that F3SG-SR/PG runs as intended.
If it does not, use SD Manager 3 to check the settings, and go back to step 3. to perform the steps
again.
10.
Turn off power of the intelligent tap and F3SG-SR/PG.
<Status of indicators at abnormal number of
beams/configuration error>
IN
:Flashing yellow at 0.5 second cycle
(quick flashing)
OUT :Flashing green at 0.5 second cycle
(quick flashing)
ERR :Red ON
<Status of indicators at abnormal number of
beams>
OUT :Flashing green at 2.0 second cycle
(slow flashing)
ERR :Not lit
Push-SW
DIP-SW
Bluetooth
®
Communication Unit
Connector
USB Type-C TM
Connector