DANGER
Activate the STOP ALL function from the control system in accordance with the
instructions in section 6.3.1. Using the STOP ALL function.
DANGER
Engage the tractor handbrake before running the calibration test. If the machine is
equipped with middle markers, close the middle marker shut-off valves in accordance
with the instructions in section 3.4. Using the middle marker ball valves.
Preparations
1. Raise the transmission cover.
Figure. 6.8.4. - 147. Calibration test with adjusting of fertiliser target rate on a machine with a dual
gearbox
2. Align the calibration trays (4) with the fertiliser side feeder shaft by turning the crank (1)
to position 1B.
The crank position 1A is for the seed side and the centre position is for seeding.
3. Check that the calibration trays are at the feeders and their lock (5) is turned to the side.
4. Remove the cotter pin (3) on the seed side from the feed shaft chain gear. If the machine
is equipped with a small seed hopper, remove the cotter pin (2) of the small seed hopper.
Figure. 6.8.4. - 148. User interface
Operation and maintenance manual
1.00
FX300 and FX400 SeedPilot
119 (208)
Summary of Contents for FX300 SeedPilot
