Multiva FX300 SeedPilot, Operation And Maintenance Manual

Page: 182 / 208

Figure. 7.9.1.2. - 247. Fastening the coulter
2. Set the lowest dampening rubber (4) in place and lift the coulter (1) against the mounting
beam.
3. Install the remaining three dampening rubbers (5).
4. Replace the mounting plate (3).
5. Install the 4 mounting bolts and nuts (2) and tighten the bolts evenly to eliminate any
gap between the mounting plates.
Use new locking nuts with a strength rating of 10 when mounting.
Figure. 7.9.1.2. - 248. Mounting the coulter cylinder
6. Insert the bottom cylinder bolt M20 X 75 (1) in the coulter mounting hole with the
bushing.
Use new locking nuts to fasten.
The bushing in the foremost coulter (3) is in the centremost hole. In the rearmost
coulter (2) the bushing is found in the rearmost hole.
Operation and maintenance manual
FX300 and FX400 SeedPilot
1.00
182 (208)