Multiva FX300 SeedPilot, Operation And Maintenance Manual

Page: 172 / 208

Figure. 7.4.3. - 230. Fastening the bearing
4. Fasten the ange bearing (2) to the axle and tighten the fastening screw (1).
If needed, replace a damaged bearing.
7.4.4. Mounting the wheel assembly
Figure. 7.4.4. - 231. Mounting the wheel assembly
1. Fasten the four bolts (1) of the ange bearing of the wheel assembly on both sides of the
wheel assembly.
The tightening torque is 230 Nm. Use new locking nuts.
2. Remove the transport supports.
3. If necessary, mount the scraper in accordance with section 5.1.7. Mounting the scraper,
the rear harrow in accordance with section 5.1.8. Mounting the rear harrow and the rear
marker cylinder in accordance with section 5.1.9. Mounting rear markers to the rear
harrow.
The wheel bolts do not need to be retightened when locking compound has been
applied during installation and the bolts have been tightened to the correct torque.
Operation and maintenance manual
FX300 and FX400 SeedPilot
1.00
172 (208)