MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 94 / 218

- 2.40 -
Origin Setting
Set an origin of data on fabric loaded on the plotter. Place the fabric and perform the fabric width
detection, the origin is automatically set at the location shown in the illustration given below.
Horizontal direction : Position 10mm apart from
the left edge of the fabric Retainer
from the right side.
Setting of an origin
If you want to perform printing at another location of a roll fabric that provides a wider printing
area, it is necessary to re-establish another origin.
• When Belt Wash in [Setup] is ON, Belt Wash is executed when jogging in
the X direction is performed. In this case, if a belt cleaning error occurs,
jogging cannot e performed.
STEP
1. After the fabric width detection is completed,
move the carriage to the position at which to
set an origin by pressing the JOG keys [ ],
[ ], [ ], and [ ].
As the carriage is moved, the origin shifts in position. The origin
that changes with the movement of the carriage is displayed on the
LCD.
2. After deciding the origin, press [ENTER] key.
The origin has been changed.
When the device starts printing the next time, it uses the origin that
has been set unless the origin is changed.
Origin Setup
X=0 Y=0
<< LOCAL >>
width : 1620mm
Origin Setup
∗∗∗∗ Origin ∗∗∗∗
Origin(Length)
Origin (width)
10 mm
Roll fabric
Fabric Retainer
Origin