MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 114 / 218

- 3.6 -
In case spots appear on the fabric during printing
In case spots appear on the fabric during printing, it may cause remaining cleaning water. Replace
the belt wiper unit with a new one or clean the water absorption roller.
• The irregular surface has occurred on the belt in case some following
condition has appeared. Make sure to apply new adhesive immediately.
(Refer to Page 5.4)
* The adhesive was applied unevenly.
* Dust, thread and tiny fleck are not able to remove from the belt even
if Washing belt function has performed.
• Make sure to wear rubber gloves for replacement.
Replacement for the belt wiper unit
In case spots appear on the fabric during printing, it may cause remaining cleaning water.
• In case replacing the belt wiper unit, contact your distributor or Mimaki
sales office to call for service.
Belt wiper unit is
located inside.