MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 82 / 218

- 2.28 -
Adjusting the number of pieces of the spiral roller
The set position of the fabric is based on the center. If the fabric is not set at the center, wrinkles are
likely to occur. In order to prevent occurrence of wrinkles during printing, use the spiral roller. The
number of pieces of the spiral roller can be adjusted according to the fabric width.
• Keep away from the spiral roller during rotating to avoid getting your hands
or belongings caught in it.
• When using the wide fabric, ravels or threads of the fabric edges may get
caught into the fixed knob of the spiral roller. In case setting those fabric,
cut the edges and then set it onto the device.
With narrow fabric, be sure to set the fabric at the center of the belt.
In the following cases, however, the center position can be changed.
• Setting the fabric with right-justification to shorten the printing time
• Keeping the life expectancy of adhesive with right- or left-justification using
a fabric with a width of 800mm or less
The pieces of the spiral roller are painted in two colors according to the rotational direction.
1. Remove the snap lock of the spiral roller on
the right-hand side of the rear face of this
device.
• When releasing the snap lock, put your
hand from under the roller. There is a risk
that the detached stopper may hit your
hand resulting in injury.
White part
Gray part