MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 69 / 218

- 2.15 -
26. Confirm the fabric feed back to the lapel bar, feed
the fabric about 1 meter by push the JOG key [ ].
27. Attach the empty fabric core.
• Attaching empty fabric core for taking
up
To take up the fabric after printing, attach
an empty fabric core to the take-up
device.
• If it is expected that the weight of the roll
increases after taking up the entire roll
(when the fabric core support pipe is used
on the loading side), use an empty fabric
core with a tube wall thickness of 10mm or
more or a fabric core support pipe on the
take-up side.
28. Pull out the fabric from under the heater and
then lead it between the empty fabric core and
the lapel bar.
• In case printing inward, fabric leads under
the paper core as illust at right.
29. Using an adhesive tape, secure the leading
edge of the fabric to the empty fabric core.
• When applying an adhesive tape, be sure
to secure the center of the fabric first and
then both edges. In this case, gently pull
the fabric to prevent it from being slack.
2) Then place two tape stops
on the left and right edges,
as shown.
1) Place a tape stop in the center
of the empty paper core.
Lapel bar
Empty fabric core