MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 202 / 218

- 6.10 -
Error messages
Error messages indicates error numbers.
If any error message is given on the LCD, turn off the power to the device and turn it on after a
while.
If the same error message appears again on the LCD, contact your local MIMAKI distributor or
MIMAKI office to call for service.
Control ROM is defective.
Control RAM is defective.
Interior power voltage becomes
abnormal.
Control ROM is defective.
Abnormal temperature is
detected.
Trouble with detection of linear
encoder.
Control circuit board is defective.
The device has received data
other than command data.
A parameter outside the range of
acceptable numeric values is
received.
The maintenance control
command is faulty.
Check the output setting of the
host computer.
A RIP from other than Mimaki
was used.
Turn off the power to the device an
turn it on after a while. If the same
error message appears again on
the LCD, contact your local
distributor to call for service.
Securely connect the interface
cable in position.
Turn off the power to the device
and turn it on after a while. If the
same error message appears
again on the LCD, contact your
local distributor to call for service.
Inapplicable color specification
data was received.
Error message Cause Corrective measure
ERROR 01
MAIN ROM
ERROR 02
MAIN RAM
ERROR 03
POWER +35V
ERROR 04
F-ROM
ERROR 07
TEMP (0000)
ERROR 08
LINEAR ENCODER
ERROR 09
FPGA
ERROR 10
COMMAND
ERROR 11
PARAMETER
ERROR 12
MAINTE COMMAND
ERROR 13
RIP LINK
ERROR 14
COLOR COMMAND
ERROR 09
HDC