MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 33 / 218

- 1.13 -
Fabric retainer
If the edge of the fabric is curled or it is raised, it may be caught by the head or inferior ink dis-
charge may occur. To avoid this trouble, use the fabric pressers. (Refer to Page1.12)
• The fabric retainer slide part also act as a detection board which detects
the printing width.
Printing with the full width (up to 1620mm width) is possible by setting the
fabric retainer to a position apart from the edge. (1620mm width or less )
• The fabric retainer is detachable for washing in case it’s stained by ink.
Remove the hand screw and then remove the fabric retainer.
• When using fabric retainer, be sure to adjust the head height to 3mm or
more. Using them with a low head height may cause damage.
Hand screw
Fabric retainer
Slide part