MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 186 / 218

- 5.16 -
Menu Displayed After The Ink Cartridge Is Installed [Ink Filling]
When the ink cartridge is replaced with a new one or a new ink cartridge is installed, this device
charges ink automatically. Maintenance function have a menu of ink change, it is not used normally.
When Replacing Different Type Of Ink [Ink Change]
The INK CHANGE function charges ink different from the one currently in use. When the same
type of ink as the ink station is to be used, it is unnecessary to execute this function.
• Be sure to use the Mimaki original ink. Please be noted that MIMAKI
ENGINEERING CO., LTD. shall have no liability for any trouble that arises
when using any ink other than the genuine MIMAKI brand ones.
• For ink replacement, head cleaning liquid is required.
STEP
1. Put the device into the MAINTENANCE mode.
(Refer to Page 5.3)
2. Press [ENTER] key.
3. Press [ ] and [ ] key until the display gives
the indication [Ink Change].
4. Press [ENTER] key.
5. Remove the relevant ink cartridge, and go to
the next step.
6. Eject the ink.
Ink is ejected from the tube, mid tank and damper.
7. Set the cleaning liquid cartridge in the lower
ink slot.
Check that there is no cleaning liquid cartridge error, and perform
cleaning.
8. Suction of the cleaning liquid starts.
9. Wash the tube, mid tank and damper with
cleaning liquid.
FUNCTION
MAINTENANCE
< ENT >
MAINTENANCE
Station
< ent >
MAINTENANCE
Ink Change
< ent >
Remove Cartridge
1 2 3 4 5 6 7 8 A B C D E F G H
Ink Change
Start
: ent
Set Washing Liq.
- - - - 5 6 7 8 - - - - E F G H
Washing 1 / 7
00:06:00
Washing 2 / 7
00:00:30