MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 41 / 218

- 1.21 -
• When the power is switched on for the first time,
the prompt for installation of ink cartridges is
displayed on the LCD.
Install the ink cartridges (Refer to Page 1.29).
• If a fabric has been set on the device, the
prompt [Media Select] is displayed on the
LCD when the power is switched on.
After selecting fabric , the device detects
the fabric and returns to the LOCAL mode.
Ink Type
Type : Acid
MEDIA SET
ROLL < > LEAF
<< LOCAL >>
width : 1620mm
Installing IEEE1394 output driver
When connecting the device using the host computer and IEEE1394 interface, it may be necessary
to install the IEEE1394 output driver and TxLink V3.
• For the installation procedure of TxLink, refer the TXLink V3 CD-ROM
supplied with the device.
Turning the power off
To turn the power off, check first whether there is received data or remaining un-output data.
Also be sure that the head rests at the capping station.
• If the power is turned off while the plotter is engaged in printing, the head
may fail to be retracted in the capping station. If the head is left without
capped for an extended period of time, the nozzle will be clogged with
dust. If the power to the device is turned off without the head capped, re-
turn on the power to the device.
If the power is turned OFF during printing, the head may not be stored in the capping station. Leav-
ing the head without capping for a prolonged period of time may cause clogged nozzle.
STEP
1. Turn off the power to the computer, etc. that
are connected to the device.
2. Turn off the power to the device.
3. Turn off the power to the heater.
4. Turn off the power to the blower.