MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 80 / 218

- 2.26 -
Removing slacks using the curved bar
If both edges of the fabric with gumming processing is extremely short with respect to the center of
the fabric (the center of the fabric is remarkably loose when the fabric is extended on the floor), use
of the curved bar is required. (Refer to “Fabric conditions which enable to print” on page 1.31.)
• The position (angle) of the curved section needs to be adjusted according
to the fabric condition.
• The rough standard position is the position at the curved bar where both
edges of the fabric slightly become loose after setting the fabric.
• Adjust the angle of R position for the vertical direction.
• The R peak position cannot be changed.
Adjusting the curved bar angle
Change the angle of the curved bar according to slacks of the fabric.
Curved bar Horizontal section: Regularly used.
R section (curved section): Used for loosen fabric in the center.
Angle adjustment
1. Use the inclination adjustment screw of the
curved bar to adjust the angle into the vertical
direction.
a. Loosen the adjustment screw
b. Turn it until the angle is gained.
• Adjust the both side of angle, with holding
the curved bar.
c. Fix it using the setscrew
2. Use the setscrew of the curved bar to adjust
the angle of the curved bar.
Adjustment screw
of the
curved bar angle
Adjustment
screw
Set screw
Horizontal section
R Section (curved section)