MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 9 / 218

- v -
During installation
• The device is as heavy as
approximately 1100 kg.
Perform the installation work
by at least six persons.
Do not disassemble or remodel the device.
• Never disassemble or
remodel the main unit of the
printer and the ink cartridge.
Disassembling/remodeling any
of them will result in electric
shocks or breakdown of the
device.
Do not use the device in damp places.
• Avoid damp environments
when putting the device into
service. Do not splash water
onto the device. High-humidity
or water will give rise to fire,
electric shocks or breakdown
of the device.
Abnormal event occurs.
• If the device is used under an
abnormal condition where the
device produces smoke or
unpleasant smell, fire or
electric shocks can result. Be
sure to turn off the power
switch imfabrictely and detach
the plug from the receptacle.
Check first to be sure that the
device no longer produces
smoke, and contact a
distributor in your district for
repair.
Never repair your device by
yourself since it is very
dangerous for you to do so.
Power supply and voltage
• Be sure to use the device
with the power supply
specifications indicated.
• Be sure to connect the plug
of the power cable to a
grounded receptacle.
If not, fire or electric shocks
can result.
Roll fabric
• Roll fabric is heavy. Be
careful not to drop it. If you
drop it on your foot, or any
other part of your body,
personal injury can result.
Handling of ink cartridges
• Store ink cartridges and
waste ink tank in a place that
is out of the reach of
children.
If ink settles on the skin or
fabric, immediately wash it
off with detergent or water.
In the event that ink gets in
eyes, immediately rinse it off
with water and consult a
medical doctor.
• Neither pound the ink
cartridge nor shake it
violently so as to prevent
leakage of ink.
• Never refill the ink cartridge
with ink. MIMAKI assumes
no responsibility for
malfunction caused by using
the device after
replenishment of ink.
Never Do the Following
WARNING