MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 110 / 218

- 3.2 -
Routine Maintenance
Be sure to conduct maintenance works for the device when necessary or periodically so as to use the
device for a long time while keeping its printing accuracy.
When the device is left unused for a long period of time
• Turn off the power to the device. (Refer to Page 2.54)
• When performing belt cleaning with “Circulate”, change dirty water in the
cleaning tank with new water, clean the inside of the pipe, and turn the
power OFF.
Notes on cleaning
• Never disassemble the device. Disassembling the device can result in
electric shock hazards and breakage of the device.
• Prevent moisture from entering inside the device. If the inner part of the
device becomes wet, electric shock hazards and breakage of the device
can result.
• Conduct maintenance works after turning off the power switch and detach-
ing the power cable. If not, unexpected troubles can arise.
• Do not use benzine, thinner and chemical agents containing abrasives.
Such materials can deteriorate or deform the surface of the cover.
• Do not apply lubricating oil or the like inside the device. Such materials
can cause the plotter mechanism to fail.
• Frequent care and cleaning is required when using printing pigment (TPig)
ink.
Maintenance for frame components
If the frame components of the device have stained, dampen a piece of soft cloth with water or
neutral detergent diluted with water, squeeze it and wipe the frame components clean.