MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 196 / 218

- 6.4 -
Fabric Problems And Solutions
Depending on the problem and fabric, some problems may not be resolved by the following solu-
tions. If the problem cannot be resolved after performing printing with any desired test data, stop
using the fabric.
Black lines occur.
1. Increase the media correction value.
2. Lighten the feeding tension bar or use
weight.
This problem is seen in fabric that
are apt to shrink when printing.
1. Reduce the media correction value.
2. Execute the head cleaning.Refer to Page 2.43
3. Clean the interior of the station. Refer to Page 3.11
4. Execute the Media Comp. Refer to Page 2.44
5. Turn ON ANR unit. Refer to Page 4.21
6. Do not touch the fabric nor the belt during printing or pause.
Conduct the [PrintAdjust] function. Refer to Page 2.37.
Adjust “Y (outward and inward)” in [PrintAdjust] function. See page 2.37.
In addition to the storage condition of the
fabric (temperature and humidity) and
storage condition of the fabric after
printing (temperature and humidity), when
performing unattended operation in
particular, pay attention to the
temperature and humidity during printing
and make them constant.
Problem Corrective measure Remarks
The color changes after post-
processing.
The respective color ink
injected by the respective
color heads do not properly
overlap
Displacement is observed
between “from to right”and
“from left to right” printing.
Coloring differs in spite of the
same fabric and pre-processing
data.
Wrinkles occur at both
edges of the fixing section of
the fabric.
Vertical wrinkles occur at the
fixing section of the fabric.
Wrinkles or slacks occur at
the center of the fabric after
the pressure roller is being
used.
White lines occur.
Thin spots are obvious.
(In the direction of travel of
the head)
Wrinkles occur at both edges of the fixing
section of the fabric.
1.Increase the weight of the feeding
tension bar or remove weight.
1. Check whether the fabric core used is
thin and does not have enough strength,
or bent. => Change the fabric core.
2. Lighten the feeding tension bar or use
weight.
3. Avoid using the spiral roller.
1. Use the curved bar.
2. Increase the weight of the feeding
tension bar or remove weight.
This problem is seen in fabric
whose gumming portion is loose
compared with the center.
This problem is seen in materials
that are thin and not firm and thin
stretch materials.
This problem is seen in fabric that
are bent or fabric whose center is
loose compared with the gumming
portion with local slacks.
Grain is bending. You should advice to
the pre-processing vender to adsjut pre-
processing to the grain. Cascade strips occures at the
horizotanl direction by printing
position
Cascade strips show up at the
data which has open lined form.