MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 59 / 218

- 2.5 -
Setting The Fabric To The Plotter
The fabric that can be used roll or leaf.
Leaf fabric is handled in the same manner as roll fabric for printing.
In case of using leaf paper for setup list printing, be careful about the setting position.
Setting a roll fablic
The procedure for setting roll fabric is described below. The following is an example, the printing
side is rolled inward.
• The roll is heavy in weight. Take care not to drop it on your foot.
• In case setting the heavy fabric the roll must be set more than 2 people.
• After setting the fabric, make sure to check that the head height has been
properly adjusted. (Refer to Page 2.33)
STEP
1. Confirm the operation panel on the LCD as the
right.
• When the fabric set is not displayed
Push the [END]key and perform the fabric
reset. (Refer to Page 2.21)
2. Insert the roll holder into the core of the left-
hand roll fabric by loosening the screw of the
left-hand roll holder at the rear side.
• If the roll exceeds 5kg, use a fabric core
more than 2 inches.
• A thin fabric core is easy to bend by the
weight of roll.
MEDIA
ROLL < > L E A F
Roll holder
Screw of Roll holder
Roll core
<The rear side of the device>