MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 107 / 218

- 2.53 -
To Set a New Ink Cartridge In the Ink Station
Set to repleuish ink, a new ink cartridge in the ink station.
In case without replacing the ink cartridge, the carriage stops during the printing operation when the
ink runs out. When the message [Ink Near End] is displayed on the LCD, install a new ink cartridge
without delay.
1. When the amount of ink completely runs out in
ink cartridge.
The amount of the indicated ink cartridge has completely run out.
Install a new ink cartridge into the ink station. This is displayed
even during plotting, and ink can be replenished.
2. When the amount of ink becomes small during
printing.
The amount of ink of the cartridge number indicated is running out.
Load a new ink cartridge with the displayed new cartridge number
into the ink station.
3. When the amount of ink completely runs out
during printing.
The amount of indicated ink has completely run out. Install a new
ink cartridge into the ink station. This is displayed even during
printing. Without replacing, the printing may stopped.
STEP
1. Either of the messages shown above is dis-
played on the LCD during printing.
The printing operation is not interrupted even when [Ink Near End]
and [Cartridge End] is displayed. Proceed to Step 2 after printing
operation has completed.
In case [Ink End] is displayed, the carriage stops during the printing
operation and then, the device enters the LOCAL mode. Follow the
step 2.
2. Install a new ink cartridge.
Pull out the ink cartridge of the indicated cartridge number and
then set a new ink cartridge.
Close the ink station cover and then, printing is started.
Ink Near End
− − − − − 6 − 8 − − − − − F − H
Ink End
1 2
− −
5 6
− −
A B
− −
E F
− −
Cartridge InkEnd
− − − 4 − − − − − B − − − − − −