MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 201 / 218

- 6.9 -
Water in the wash tray is
overflowed.
Check media is not available.
ANR detected irregular nozzle.
ANRS check media remains a
few.
ANR Unit detected irregular
nozzle.
The filter of the cleaning liquid tank
is clogged or the hose is clogged
by dust. Change the filter and
clean the hose exit.
Prepares the new check media.
Push the [ENTER] key to perform
cleaning of the print head.
(Refer to Page 2.43)
It prepares check media.
Perform the head cleaning.
(Refer to Page 2.43)
Warning message Cause Corrective measure
Belt Wash
Tray Overflow
Service Call
101
ANR Unit
No Check Media
ANR Unit
Head Clean [ENT]
Service Call
102
Service Call
111
Service Call
112
ANR Unit
Media Near End
ANR Unit
Print Stop
Time to change the rewinding
motor.
Time to change the winding
motor.
Time to change the red LED.
Time to change the blue LED.
Peeling sensor light intensity
have been decreased.
The device can be used
continuously. However, contact
your dealer or Mimaki sales office.
Belt Adhesive
300m To Go
Time to reapply adhesive to the
belt.
Belt Adhesive
Reapply Adhesive
Time to reapply adhesive to the
belt.
Water Absorption
Check The Roller
Time to check the water
absorption roller.
Apply a new adhesive to the belt
(Refer to Page 5.4, 5.20).
Then, execute Maintenance
Function-Counter Reset to reset
the counter of “Adhesive”.
Clean the absorption roller
(Refer to Page 3.7, 5.20).
Then, execute Maintenance
Function-Counter Reset to reset
the counter of “Absorb Rlr.”
Service Call
133
Peeling sensor needs to service
maintenance.The device can be
used continuously. However,
contact your dealer or Mimaki
sales office.