MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 78 / 218

- 2.24 -
Adjusting the Pressure Roller Position
Apply pressure to make the fabric adhere to the belt. There are three different pressure levels.
Pressure level of the pressure roller
Low
: Use this pressure level immediately when adhesive is applied again.
Middle : Since a stretch material expands at the time of peeling, high tension may
cause the fabric to be caught by the belt. While the adhesive force is strong,
use the Low or Middle position.
High
: In case the adhesive force has decreased and using a silk material, use the
High position.
• The above is merely a rough standard. Be sure to check the sticking condi-
tion before setting the position.
• Since the pressure roller is very heavy, be careful not to get your finger
caught by the roller when setting or putting aside the roller.
• If the pressure roller is left on the belt without fabric setting for a prolonged
period of time, the roller will stick to the belt, making it difficult to remove the
roller. If you do not set the fabric, put aside the pressure roller from the belt.
• If it is left for a long time, feeding it slightly with JOG makes it easier to
remove.