INTERFERENCE TO TELEVISIONS AND RADIOS
The product covered by this Instruction Manual produces low radio waves while it is in
operation. The product can interfere with radios and televisions if set up or commissioned
under improper conditions. The product is not guaranteed against any damage to specific-
purpose radio and televisions.
The product’s interference with your radio or television will be checked by turning on/off
the power switch of the product.
In the event that the product is the cause of interference, try to eliminate it by taking one of
the following corrective measures or taking some of them in combination.
•
Change the direction of the receiving antenna or the feeder of your
radio/television.
•
Change the installing direction of the product.
•
Move the receiver away from the product.
•
Use a power line for the receiver that is not shared with the prod-
uct.
LASER SAFETY
This Model is certified as a Class I laser product under the U.S. Department of Health and
Human Services Radiation Performance standard according to the Radiation Control for
Health and Safety Act of 1968. This means that this Model does not produce hazardous
laser radiation.
CDRH REGULATION
The Center for Devices and Radiological Health for the U.S. Food and Drug Administration
Implement regulations for laser products. The Label shown below indicates compliance
with the CDRH regulations and is labeled on the product when marketed in the United
States. This Model is equivalent to Class I laser device according to CDRH Regulation.
FCC Statement (USA)
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference when the equipment is operated in a commer-
cial environment. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in
which cause the user will be required to correct the interference at his own expense.
•
In the case where MIMAKI-recommended cable is not used for
connection of this device, limits provided by FCC rules can
be exceeded. To prevent this, use of MIMAKI-recommended
cable is essential for the connection of this device.
This product complies with 21 CFR chapter I and subchapter J.
Summary of Contents for Textile Jet Tx3-1600
