MIMAKI Textile Jet Tx3-1600, Operation Manual

Page: 104 / 218

- 2.50 -
Other Settings
Cleaning the belt during printing
Ink penetrates thin fabric of chiffon (georgette), voile, organdy, etc., resulting in adhesion on the
belt. The ink adhered belt will not be dried when moved to the fixing position, then the clean
stretched fabric may be stained. To avoid this, clean the belt.
There are the following two different belt cleaning methods:
• Supplying the circulating water from the cleaning liquid tank at factory
setting. The connection to service water directly cannot be installed by the
customer. In case changing needs to the connection to service water
directly, contact your local distributor to call for a service.
• In case spots appear on the fabric during belt cleaning, the belt wiper unit
which has reached the serves life replace with a new one, or clean the
absorption roller. (Refer to Page 3.6, 3.7~ and Appendix “Supply Parts” )
Belt cleaning by circulating water from the cleaning liquid tank
• When belt cleaning is performed by circulating cleaning water, cleaning
water becomes dirty immediately. Be sure to change cleaning water on a
daily basis. Dirt cleaning water or high content of ink, dust, or garbage may
cause damage to the circulation pump or clogging in the filling port of the
cleaning pipe, etc. resulting in degraded cleaning effect.
• Dispose of polluted cleaning water according to the local regulations in the
same manner as waste ink.
1. Make sure that the device is in the LOCAL
mode.
2. Press [FUNCTION] key.
3. Press [ENTER] key twice.
4. Select [Belt Wash] by pressing the JOG keys
[ ] and [ ].
5. Press [ENTER] key.
TYPE1
Media Comp.
< ent >
TYPE1
Belt Wash
< ent >
SETUP
Select
: TYPE1
• Belt cleaning by circulating water
from the cleaning liquid tank:
• Belt cleaning by circulating water
through connection to service water:
Fabric with much ink penetration
Fabric with a little ink penetration
<<LOCAL>>
width : 1620mm
TYPE1
Belt Wash
: OFF