Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 80 of 195
Page 80 of 195
chars.
No
special
characters
allowed except
_ . , [ ]
Default: masibus
28
-
SNMP Location
User
defined
string
SNMP
system
location
information
Note
:
Min
– 4 chars, Max – 38
chars.
No
special
characters
allowed except
_ . , [ ]
Default: Gandhingar
After the SNMP Manager parameters are configured, it is necessary to restart the SNMP service using
SNMP failing to which SNMP communication will be according to old or previous settings. SNMP service
operation depends on snmpd.conf configuration file contents which are automatically created according to
SNMP settings as per above table once SNMP service is restarted or started after being stop.
9.2.4
Ethernet Settings:
MTS200 Ethernet network parameters required to configure MTS200 eth0 and eth1 (optional) network IP
parameters. This parameters need to setup whenever there is change in IP address of device eth0 or
eth1 port or if any service in MTS200 is to be restarted. This mode is also used to configure syslog server
address in MTS200.
User need to enter “ETH” or “eth” in main menu of console based configuration utility as shown in below
figure.
