Model: MTS200 (1U)
Doc. Ref. no. : m08/om/201
Issue no. : 03
User’s Manual
Page 60 of 195
Page 60 of 195
the position
of blinking cursor use “LEFT” / ”RIGHT” arrow keys. UP/DOWN arrow keys will update the
digit on which cursor is blinking.
After value is edited, press “OK” again to save the parameter or "ESC" to restore parameter value. After
user presses “OK” key, user can view changed IPv6 gateway.
8. DHCP
Here, user can configure both Ethernet ports to be dynamically configured using DHCP protocol for IPv4.
For dynamic allocation of network address, user have to select ENABLE for ETH DHCP and press OK
key to save changes as shown in figure.
Note:
Once DHCP service is enabled, device will start communication with available DHCP server in
network and as a result, it may take few seconds for getting dynamic IP address from DHCP server.
User can check the
allocated DHCP IP address in “IP Address” menu on LCD display.
If bonding is enabled, eth0 DHCP will only be effective in use.
Refer section 13.6 for further details
NOTE :
1. If MTS200 is provided with only single Ethernet option, the other Ethernet port related
parameters/configurations will be disabled and not accessible by operator.
Ethernet Services
As explained above, various network services such as Telnet, SSH, HTTP, HTTPS, FTP, SNMP can be
set through keypad. Refer below figure.
