Model: MTS200 (1U)
Doc. Ref. no. : - m08/om/201
Issue no.: 03
Page 83 of 195
User’s Manual
Default: ::
8
Eth0 IPv6 Netmask
0 to 128
This is v6 format subnet mask address
for eth0 port.
Default: 0
9
Eth0 IPv6 Gateway
Valid
IPv6
address
This is v6 format gateway address for
eth0 port.
Default: ::
Below table provide each parameter description for Ethernet1 network parameters.
Command Parameter
Applicable
Value
Description
1
Eth1
IPv4
DHCP
Service
0 / 1
To enable DHCP on eth1 network.
Configure this parameter will enable
eth0 to acquire dynamic IPv4 address
from DHCP server in network. This
mode is mainly helpful whenever
MTS200 is connected in network for
first time before installation complete.
If DHCP server is not present,
configure this as “0”.
Setting eth0 to DHCP will make static
configuration of IPv4 eth1 network
address meaningless.
Default: 1
2
Eth1 IPv4 Address
xxx.xxx.xxx.xxx This is v4 format IP address for eth1
port.
Default: 0.0.0.0
3
Eth1 IPv4 Gateway
xxx.xxx.xxx.xxx This is v4 format gateway address for
eth1 port.
Default: 0.0.0.0
4
Eth1 IPv4 Netmask
xxx.xxx.xxx.xxx This is v4 format subnet mask address
for eth1 port.
Default: 255.255.255.0
5
Eth1 IPv6 Autoconf
0 / 1
To enable Autoconf on Eth1 network.
Configure this parameter will enable
eth1 to acquire IPv6 address from
network. This mode is mainly helpful
whenever MTS200 is connected in
IPv6 network for first time.
Setting eth0 to Autoconf will make
static configuration of IPv6 eth1
network address unusable and will be
replaced by automatically acquired
IPv6 addresses.
Default: 1
6
Eth1 IPv6 Link-Local
Address
Non-
configurable
Eth1 will have this address whenever
IPv6 service is enabled and link for
Eth1 is live.
Default : ::
7
Eth1 IPv6 Address
Valid
IPv6
address
This is v6 format IP address for eth1
port.
Default: ::
